Nano Protect Leather is a specially developed, anti-bacterial skin polishing cream. Its composition ensures hardening of the surface of the skin and thus its greater abrasion resistance and protection against UV radiation causing color fading. Antibacterial effect prevents the bacteria from growing on the surface. The product deepens the skin, softens it and delivers the necessary luster. Nano Protect Leather does not close pores on the surface, so the skin is "breathing". This is due to the fact that the composition forms on the surface a kind of membrane that does not drop water drops, but on the contrary passes many smaller particles of steam or water of saturated air. The skin is then less dirty, better cleaned, and different molds and bacterial cultures do not spread on its surface. The skin is much better resistant to normal wear and tear, such as seating and subsequent friction when moving people on a sofa. The surface membrane contains nanoparticles that are deposited in the rough skin structure just below the surface. The whole system is so hardened and lasts longer than usual with various wax and oil based products. The composition contains ingredients and vitamins, soothing and nourishing skin, which remain in the skin structure. At the same time, thanks to the membrane, it almost does not let it out and thus the skin is nourished and protected at all times.
The total area to which protection is sufficient is 30 m2.
Instructions for use
Shake the preparation thoroughly before use. In the case of application below 20 ° C, it is recommended to heat the device by inserting the bottle into a bath with warm water of approx. 40-50 ° C for about 3-5 minutes. The formula softens. Shake again. Apply it to the surface thoroughly cleaned with Nano Clean Leather.
Apply in a small amount using a clean cloth or pad (Pikatec accessory sponge) and then spread lightly evenly so that the product is "poured" into the skin. It is not suitable for Alcantara dry skin, because it underlines gloss. In the case of perforated leather (with holes), apply a thin layer of cloth to the cloth and spread it on a smooth surface first, to lightly inject the cloth into the cloth. Then spread the perforated skin so that the device does not stick into the holes and does not stick to it. It is similar to other skin care products.
After spraying, let it work for about 1 hour after grinding with a soft cloth. Prior to application of the second coat (recommended for old or overcoated skins), the first layer must be dried on the surface and must not stick to the touch. Apply and spread the second coat very finely, so as not to damage the previous layer or apply it after several hours. The second layer has to be blurred.
The last phase is polymerization, when the Nano Protect Leather hardens about 12 hours after spraying of the final layer and has the ultimate strength and elasticity.