This new version has the following features compared to the first version of the HOME range: new additives improving water repellency, better grease repellency, dust particles and better grip.
Perhaps the hardest anywhere in the home in interiors and exteriors is the maintenance of plastic surfaces. Their structure is very rough under the microscope, and just washing is actually dissolving the dirt and then spreading it into the surface. It looks like it sends, the white color gray and also yellow with UV light. Over time, the surface appears to be no longer washable and is permanently dirty. A new, revolutionary formula for nanotechnology that creates an invisible transparent nanoparticle layer (billions of meters) on the plastic surface, a kind of hard shield. It penetrates the pores in the plastic structure and closes it, protecting it from the surface. Smooths its surface and, thanks to the presence of hard oxide nanoparticles, it strengthens it. Polar UV filters significantly reduce damage and breakdown of polymers (plastics) due to UV radiation and maintain their color stability. It has a long-lasting effect (12 months), ensures high gloss, protection against scratches from small impurities and dust, protection against salt influences, chemicals, detergents, pollen and resin from trees, bird feces and UV rays. Apply polish only to surfaces that are pre-washed and cleaned.
The total area to which protection is sufficient is 6 m2.
Instructions for use
Shake the preparation thoroughly before use. Apply to dry, clean and degreased surfaces. Apply in a small amount using Padu (Pikatec accessory sponge) and then lightly spread evenly so that the product is "poured" into the plastic structure for visible film. Let it dry for about 30 minutes when the film lightly lightens and polish it with a high gloss with a cloth.
Coarse and patterned plastics behave alike if you polish directly into the patterned pattern of plastic, the polishing is there, and if it does not break you with a rag, it can make a shiny spot in this place. In this case, it is necessary to start the Nano Clean Surface (you can also use Nano Clear Glass) in the desired appearance after 2 minutes (up to 30 minutes) after polishing. However, it is better to apply a sponge to the sponge (Pikatec accessory), lightly clamping the sponge to get this polish into the molten structure, and then overlay the patterned plastic. White plastics and smooth any color plastics are, of course, scattered very simply and in any way. This passage only highlights some of the materials and structures that application of temporary agents would cause when applying any agent.
Do not apply in direct sunlight, but after 90 minutes the surface may be exposed to direct sunlight. The polishing solids from above, so under the hardening top layer there is still a soft lower part of the polish for 12 hours. The optimal protective effect and hardness occurs after 12 hours when the nanoparticles settle on the surface to form a shield (crystalline grid). During this time, a very thin layer of very slightly visible powder that is not water repellent and which can be washed with a damp cloth is eliminated. Water repellency occurs after washing this layer and every subsequent wash, these properties improve for some time.