A new formula of nano-preparation that highlights lacquer. In the first phase it is used to clean and remove impurities before Ceramic Nano Armour (nano-polish for car bodywork) is applied. In the second phase it is used to maintain the surface of the bodywork after Ceramic Nano Armour has been applied and to prolong the service life of this polish. After the polish has been applied try to avoid the use of industrial detergents on the car if possible. (They often destroy all protective polishes and surfaces, including wax.) However, the new formula has also significantly improved the resistance to these detergents. A treated surface of the bodywork exposed to washing (15 times) with a very strong detergent solution has lost only 10 % of its hydrophobic properties. (Test with detergent: 50 ml of detergent in 2 litres of water – each time washing an identical spot on the bodywork for one minute).
Nanoparticles (billionths of a metre) easily penetrate pores on the surface and remove stains caused by oil and insects. This preparation is optimised for manually washing car, ship and motorcycle bodywork. It is harmless to the environment.
NEW SERIES OF PIKATEC CERAMIC
The revolutionary new series of PIKATEC CERAMIC nanocosmetics is derived from the supreme DIAMOND series; however it has been optimised to be affordable to the wider public. It provides high UV protection for lacquer and gives a hardness and resistance to abrasion several times better the previous cosmetic series. It is more water repellent and seals pores in lacquer for a period of up to one year. Its setting time is shorter and it is very resistant to industrial detergents. It is extremely resistant to heat – up to around 550°C.
The PIKATEC CERAMIC series is specially developed and produced from self-supporting emulsion and nanoparticles of a size of up to 30 nm (nm – nanometre – one billionth of a metre), which are permanently dissolved in the liquid environment of the new generation cosmetic emulsion thanks to a special solvent. These solid particles contain silicon oxide and zircon oxide, which together improve the repelling properties in relation to liquids as wells as resistance to mechanical surface wear and tear. Other components of the revolutionary PIKATEC CERAMIC cosmetics provide a protective shield against other impurities, chemicals and salts, but most of all they provide a perfect UV filter against UV radiation.
Instructions for use:
Shake well before use. The recommended dilution ratio is 1 : 300. That means approximately 30ml of shampoo per 10l of clean water.
If the bodywork is quite clean it is possible to use a lower concentration – 15ml per 10l of water. On the other hand if the bodywork is heavily soiled it is possible to use a stronger concentration of up to 1 : 30. Mix water with the shampoo and leave it to stand for about 2 minutes. Using a soft sponge, clean the bodywork with circular motions. Do not forget that the better you clean the surface the better the adhesive properties and service life of the subsequent polish will be! In cases of extremely dirty bodywork do not hesitate to wash your car two or more times.
CAUTION – the most frequent reason for failures in application is when the surface that has not been properly degreased! The use of greasy preparations, such as clay or similar, or a preliminary washing of the car in an automatic car wash (where waste water with spray wax is usually recycled) may reduce the effect and shorten the service life of PIKATEC polish. Also air compressors, used to dry the car body, sometimes exude oil, which is used to lubricate the compressor’s piston, along with the air – this is often the case unless the compressor is equipped with a filter.
Do not apply under direct sunlight!
Watch video instructions at www.pikatec.cz or you can use the QR code.